Agilent Technologies 8960 Series Reference Manual page 98

Step 7: End Connection
Releasing an Active Call from the Mobile Station Figure 10. Process for Terminating an Active
Call from the Mobile Station
NOTE The test set cannot initiate a call disconnection from the mobile station. You must manually push
the end button on the mobile station or send commands to a test bus built into the mobile station.
For a mobile station release where the call is terminated by physically pushing a button on the
phone (as opposed to using a test bus) ensure that the call-state-change-detector timeout time is
long enough to allow the end button to be pushed.
98
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_prog_generic_step7.fm
Start
Send
CALL:CONN:TIM
command.
Send
CALL:CONN:ARM
command.
Send CALL:CONN?
query command.
Terminate the call
from mobile station.
Enter response from
CALL:CONN? query.
Call connected?
No
Proceed with control
program.
Yes
Invoke error
handler.