Agilent Technologies 8960 Series Reference Manual page 306

SETup:WCPower
SETup:WCPower:TIMeout:STATe
Function Sets/queries the channel power measurement's timeout (see
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"SETUP:WCPOWER:TIMEOUT:STATE ON"
SETup:WCPower:TIMeout:TIME
Function Sets/queries the channel power measurement's timeout (see
be used when the timeout state is set to ON.
Setting Range: 0.1 to 999.9 seconds
Resolution: 0.1 second
Query Range: 0.1 to 999.9
*RST Setting 10 seconds
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"SETUP:WCPOWER:TIMEOUT:TIME 5 S"
SETup:WCPower:TRIGger:DELay
Function Sets/queries the channel power measurement's trigger delay setting.
This setting can be used to delay the measurement trigger in order to start a measurement
during a specific timeslot in the frame. For example, a 1.333 ms delay would cause the trigger to
wait until after the first two timeslots have elapsed.
Setting Range: -10 to 10 milliseconds
Resolution: 0.0001 millisecond
Query Range: -10 to 10 milliseconds
*RST Setting 0 seconds
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"SETUP:WCPOWER:TRIGGER:DELAY 1MS"
306
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_hpib_setup_wcpower.fm
"Measurement Timeouts"
"Measurement Timeouts"
) state.
) setting to