Effects On Receiver Control When Changing Operating Mode; Related Topics - Agilent Technologies 8960 Series Reference Manual

Measurement receiver frequency
Measurement receiver frequency commands are used to manually tune the test set's measurement
downconverter input signal path (see
quality, and adjacent channel leakage ratio measurements.
The commands are:
• "RFANalyzer:MANual:MEASurement[:MFRequency]"
• "RFANalyzer:CONTrol:MEASurement:FREQuency:AUTO"
• "RFANalyzer:MANual:MEASurement:FREQuency"
Demodulation (uplink) receiver frequency
Demodulation receiver frequency commands are used to manually tune the test set's demodulation
downconverter input signal path (see
of the function that demodulates information from the mobile station's (UE) uplink channel transmission. This
path is used by the loopback bit error ratio measurement.
The commands are:
• "RFANalyzer:MANual:UPLink[:MFRequency]"
• "RFANalyzer:CONTrol:UPLink:FREQuency:AUTO"
• "RFANalyzer:MANual:UPLink:FREQuency"

Effects on Receiver Control When Changing Operating Mode

After selecting the operating mode and setting one or more receiver controls to manual, the receiver control
settings remain as you set them until you change operating mode. Changing operating mode causes some or
all receiver parameters to return to automatic control.

Related Topics

"RFANalyzer"
"CW Operating Mode"
"FDD Test Operating Mode"
"Block Diagram" ). This path is used by the channel power, waveform
(to specify a frequency and turn manual mode on)
(to specify a frequency)
"Block Diagram" ). The demodulation downconverter signal path is part
(to specify a frequency and turn manual mode on)
(to turn manual mode on/off)
(to specify a frequency)
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_gen_bse_rcvr_test.fm
(to turn manual mode on/off)
Receiver Control
121