Agilent Technologies 8960 Series Reference Manual page 192

CALL:FDDTest
CALL:FDDTest:CLPControl:UPLink:MODE
Function Sets/queries the uplink inner loop power control mode.
When UP is selected, the test set sends all 0 (up) power control bits.
When DOWN is selected, the test set sends all 1 (down) power control bits.
When UDOWn is selected, the test set sends alternating up/down power control bits.
When UDOWn10 is selected, the test set sends alternating 10 up/down power control bits.
Setting Range: UP|DOWN|UDOWn|UDOWn10
Query Range:UP|DOWN|UDOW|UDOW10
*RST Setting UDOW
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"CALL:CELL:CLPCONTROL:REVERSE:MODE UDOWN"
!Sets the closed loop power control mode to alternating up, down bits.
CALL:FDDTest:CCPChannel:PRIMary:STATe
Function Sets/queries the primary common control physical channel's state in test mode.
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 1 (on)
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"CALL:FDDTEST:CCPCHANNEL:PRIMARY:STATE ON"
CALL:FDDTest:CPIChannel[:SLEVel]
Function Sets/queries the test mode power offset of the common pilot channel . This command sets the
power offset level and turns on the power offset.
Setting Range: -20.00 dB to 0 dB
Resolution: 0.01
Query Range: -20.00 dB to 0 dB
Resolution: 0.01
*RST Setting -3.3 dB
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"CALL:FDDTEST:CPICHANNEL:SLEVEL -10"
192
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_hpib_call_fddtest.fm