Save/Recall Setup And Waveform; Signal Triggering - Agilent Technologies U1604A Quick Start Manual

Save/Recall Setup and Waveform

To enter Save/Recall mode, press and hold the Run/Stop button. This
function allows you to save up to 10 waveforms and configuration settings
into the unit's internal memory or an external USB flash memory device
(optional).
Table 5 Function descriptions of save and recall menu with and without USB flash memory connected
Scenario Sub Menu
USB flash Save/Load Setup
memory
Save/Load Waveform
not
connected
Erase Setup
Erase Waveform
USB flash Save
memory
Recall
connected
Erase
Clear Waveform

Signal Triggering

This signal triggering function aims to obtain a stable and representative
signal display from an unstable signal. This function triggers the scope
when to start acquiring data and display a waveform based on the
selected trigger type. To enter trigger menu, press Trigger button.
Table 6 Function descriptions of trigger menu
Trigger Menu
Edge Trigger More 1/2
page
More 2/2
page
Description
Save or recall configuration setting
Save or recall waveform
Delete stored configuration setting
Delete stored waveform
Save waveform or configuration setting
Download waveform or configuration setting from USB memory device
Delete saved file
Delete the recalled waveform and configuration setting display on screen
Sub Menu Description
Source To select channel source 1 or 2 for triggering
Slope To select rising and falling slope
Coupling To select input coupling to DC, AC, HF-Rej (High Frequency Reject),
LF-Rej (Low Frequency Reject) or Noise-Rej (Noise Reject)
Level To set trigger level for Manual, TTL, ECL or Set to 50%.
For manual adjustment, change the rigger level by turning rotary
switch
12