WCDMA Measurements Using FDD Test Operating Mode
Measuring Channel Power
1. Configure the mobile station to generate a 12.2 kbps reference measurement channel (RMC) uplink signal
on the correct frequency using the test set's FDD Test operating mode.
2. Press the
key.
Measurement selection
3. Select the Channel Power measurement.
4. Press the Channel Power Setup (
) key.
F1
5. Set the measurement parameters as needed for your measurement situation.
A typical channel power measurement result is shown above.
424
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_man_measurements.fm