WCDMA Measurements Using FDD Test Operating Mode
The following step-by-step procedures explain how to perform specific measurements available on the
WCDMA Test Application while using FDD Test operating mode.
FDD Test operating mode requires manual synchronization of the test set and the mobile station before the
mobile station can generate an uplink signal that can be measured in the following procedures. See
Measurements on a Mobile in FDD Test Mode"
Detailed descriptions for each measurement and the FDD Test operating mode are provided in the Reference
information on the documentation CD-ROM and at the Agilent 8960 support website
(www.agilent.com/find/8960support).
Setup parameters for each measurement are assumed to be set to their default (full preset) values unless
otherwise stated.
The following measurement procedures are provided:
•
"Measuring Adjacent Channel Leakage Ratio" on page 423
•
"Measuring Channel Power" on page 424
•
"Measuring Loopback Bit Error Ratio" on page 425
•
"Measuring Thermal Power" on page 426
•
"Measuring Waveform Quality" on page 427
WCDMA Measurements Using FDD Test Operating Mode
.
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_man_measurements.fm
"Making
422