Setup[:All]:Continuous - Agilent Technologies 8960 Series Reference Manual

SETup[:ALL]:CONTinuous

SETup
[:ALL]
"Diagram Conventions" on page 168
SETup[:ALL]:CONTinuous
Function Sets/queries the trigger arm state for all measurements. Determines whether all measurements
will make one measurement then stop (OFF (single)), or automatically rearm upon completion of
one measurement and repeat the process (ON (continuous)).
This setting overrides previously set trigger arm settings for individual measurements.
Setting Range: ON, OFF
Programming Example
OUTPUT 714;"SETup:ALL:CONTinuous:OFF" !Sets all measurements to single trigger mode.
:CONTinuous
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_hpib_setup_all_continuous.fm
SETup[:ALL]:CONTinuous
:OFF
:ON
284