Uplink Settings; Receiver Control Settings; Related Topics - Agilent Technologies 8960 Series Reference Manual

FDD Test Operating Mode
RF Generator Frequency
To set a downlink frequency that does not correspond to a defined channel number, you can set the RF
generator frequency control to manual. When manual RF generator control is used, the downlink channel (DL
Channel) control is replaced by the RF generator frequency (RF Gen Freq Ctrl) control to allow manual entry
of the RF generator frequency. See "CALL[:CELL]:CONTrol:DOWNlink:FREQuency:AUTO" and
"CALL[:CELL]:RFGenerator:FREQuency" .

Uplink Settings

Closed Loop Power Control Data
Closed loop power control data can be set using four formats: alternating (up/down) bits, all up bits, all down
bits, 10 up bits & 10 down bits. See "CALL:FDDTest:CLPControl:UPLink:MODE" .
Uplink Channel
When the test set is using automatic receiver control (the default), the uplink channel setting sets the test set's
receivers to the expected UE uplink channel frequency. If manual receiver control is selected, the
Measurement Frequency and Uplink Frequency settings are used to manually enter the receiver frequencies.
See "CALL:UPLink:CHANnel" . See also "Receiver Control" for information about automatic and manual
receiver settings.
Uplink Scrambling Code
This setting tells the test set which scrambling code to use to decode the uplink signal from the UE (mobile
station). This setting must match the UE uplink scrambling code to make waveform quality and loopback bit
error ratio measurements. See "CALL:UPLink:DPCHannel:SCODe" .

Receiver Control Settings

The expected power into the test set, and the frequency of the signal being measured, can be set either
automatically or manually. Automatic receiver control is the default mode, and provides the simplest form of
operation. Manual control is typically used to enter values that are different from those normally set during
automatic control. See "Receiver Control" for more information on how manual and automatic receiver control
are used.

Related Topics

"CW Operating Mode"
"Receiver Control"
"Programming: Getting Started Guide for E1963A W-CDMA Mobile Test Application Revision A.01"
56
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_gen_bse_fddtest.fm