Table of Contents
Advertisement
4.1
GENERAL
The CSMIM-T1 comes with software that supports specific commands
and parameters for the configuration and administration of the
CSMIM-T1 module. These commands cannot be accessed through the
console port. You must either telnet into the CSMIM-T1 from another IP
address, or you may use the NA utility. Also note that these commands are
not available until after the unit has successfully booted. The following
sections describe the commands and parameters, and Section 4.5 provides
an example of how to use them.
4.2
T-1 COMMANDS
The CSMIM-T1 software comes with the following new or enhanced
commands:
Command
stats -T
show
set
reset
t1_loopback
CSMIM-T1 Hardware Installation Guide
CHAPTER 4
CSMIM-T1 PARAMETERS
Table 4-1 T1-related Commands
Command Type
CLI
admin / na
admin / na
admin / na
Superuser CLI
Description
Displays T-1 Network Interface
statistics.
Shows a T-1 configuration parameter.
Sets a T-1 configuration parameter.
Resets the T-1 engine and ESF
statistics.
Places the T-1 engine into loopback
mode.
4-1
Advertisement
Table of Contents
