Ospfv3 Over Ipsec Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

OSPFv3 over IPSec Configuration
© Copyright Lenovo 2017
The following table describes the OSPFv3 over IPsec Configuration commands.
Table 279.
Layer 3 IPsec Configuration Options
Command Syntax and Usage
ipv6 ospf authentication ipsec enable
Enables IPsec.
Command mode: Interface IP
ipv6 ospf authentication ipsec spi <256‐4294967295> {md5|sha1}
<authentication key (hexadecimal)>
Configures the Security Parameters Index (SPI), algorithm, and authentication
key for the Authentication Header (AH). The algorithms supported are:
MD5 (hexadecimal key length is 32)

SHA1 (hexadecimal key length is 40)

Command mode: Interface IP
no ipv6 ospf authentication ipsec spi <256‐4294967295>
Disables the specified Authentication Header (AH) SPI.
Command mode: Interface IP
ipv6 ospf authentication ipsec default
Resets the Authentication Header (AH) configuration to default values.
Command mode: Interface IP
ipv6 ospf encryption ipsec enable
Enables OSPFv3 encryption for this interface.
Command mode: Interface IP
Chapter 4: Configuration Commands
505