Setup Part 4: Ip Configuration; Ip Interfaces - Lenovo ThinkSystem NE2552E Application Manual

Setup Part 4: IP Configuration

IP Interfaces

1. Select the IP interface to configure, or skip interface configuration at the prompt:
2. For the specified IP interface, enter the IP address in IPv4 dotted decimal notation:
3. At the prompt, enter the IPv4 subnet mask in dotted decimal notation:
4. If configuring VLANs, specify a VLAN for the interface.
© Copyright Lenovo 2018
The system prompts for IPv4 parameters.
Although the switch supports both IPv4 and IPv6 networks, the Setup utility
permits only IPv4 configuration. For IPv6 configuration, see "Internet Protocol
Version 6" on page 325.
IP interfaces are used for defining the networks to which the switch belongs.
Up to 128 IP interfaces can be configured on the NE2552E Flex Switch (NE2552E).
The IP address assigned to each IP interface provides the switch with an IP
presence on your network. No two IP interfaces can be on the same IP network.
The interfaces can be used for connecting to the switch for remote configuration,
and for routing between subnets and VLANs (if used).
Note: Interface 128 is reserved for IPv4 switch management.
IP Config:
IP interfaces:
Enter interface number:
If you wish to configure individual IP interfaces, enter the number of the IP
interface you wish to configure. To skip IP interface configuration, press <Enter>
without typing an interface number and go to "Default Gateways" on page
Current IP address:
Enter new IP address:
To keep the current setting, press <Enter>.
Current subnet mask:
Enter new subnet mask:
To keep the current setting, press <Enter>.
This prompt appears if you selected to configure VLANs back in Part 1:
Current VLAN: 1
Enter new VLAN [2-4094]:
Enter the number for the VLAN to which the interface belongs, or press <Enter>
without specifying a VLAN number to accept the current setting.
(1-125, 127)
0.0.0.0
0.0.0.0
66.
65
Chapter 2: Initial Setup