Calibrating The Touch Screen - Spectra TFinity User Manual

Chapter 14 — Maintaining the Library
11. Plug the free end of each power cord into an appropriate power source.
12. Repeat the entire process for the power cords attached to the dual AC
13. After cord locks are installed on all of the power cords, set the AC
C
ALIBRATING THE
If the touch points on the library's touch screen do not properly align with
the user interface graphics, perform the following procedure to recalibrate
the position of the touch points.
1. Log into the library as a user with superuser or administrator
2. From the toolbar menu, select Maintenance > Tools to display the
3. Select Utilities. The Utilities screen displays.
4. Select Calibrate Touch Screen.
5. Click Run Utility. The touch screen displays a series of calibration target
6. Touch each point as it displays with either the stylus or your finger to
7. When the calibration routine is complete, the Utilities screen
November 2020
module in each drive expansion frame and the expansion power
module in each service frame.
breaker switches to the "on" position and power on the library.
T S
OUCH CREEN
Note: You must perform this procedure while standing in front of the
touch screen. The utility is not available when accessing the
library through the BlueScale web interface (RLC).
privileges.
Maintenance Tools screen (Figure 275 on page 441).
points.
recalibrate the touch points on the screen.
Note: Touch each point at a straight‐on angle as close to the center of
the target as possible.
redisplays.
Manage Update Packages
User Guide—Spectra TFinity Library
463