Spectra TFinity User Manual page 434

Chapter 13 — Drive Troubleshooting
6. On the DLM Select Scratch Cartridge screen, select the scratch cartridge
If the entry/exit pool contains multiple data cartridges, make sure that you select a
Caution
cartridge that does not contain data that you want to retain. The test process
overwrites all data on the tape.
7. Click Next to begin the automatic test process. A series of status screens
8. When the test is complete, review the DLM Test Results screen to
9. Click Continue to return to the Drives screen.
November 2020
you want to use for the test.
Note: Only data cartridges located in the partition's entry/exit pool are
listed and available for selection.
Figure 267 The DLM Select Scratch Cartridge screen.
lets you know how the test is progressing. The test process requires
approximately 15 minutes to complete.
determine the outcome of the test and respond as required.
 If the drive passes the test, the drive health is set to Good (green).
You can continue using the drive.
Figure 268 The DLM Test Results screen (test successful).
 If the drive fails the test, the drive health is set to Poor (red). Contact
Spectra Logic for assistance (see Contacting Spectra Logic on
page 7).
Figure 269 The DLM Test Results screen (test failed).
Run the DLM Drive Health Verification Wizard
User Guide—Spectra TFinity Library
434