Spectra TFinity User Manual page 419

Chapter 13 — Drive Troubleshooting
LTO SCD Codes
SCD Code Descriptions for LTO Drives. The following table shows the SCD
codes and, where applicable the associated DLM Drive Health icon, for
LTO drives supported by the library. See the table on page 334 for a
description of what the Drive Health icons indicate. For TS11xx technology
MCD codes, see TS11xx Technology MCD Codes on page 425.
Code DLM
Health
Icon
0
1
2
November 2020
The single‐character display does not use the characters B, D, G,
Note:
I, O and Z to prevent misinterpretation as the characters 8, 0, 6, 2,
and 1.
Cause and Solution
No error occurred. No action is required.
The power was cycled or diagnostics have finished with no errors.
Cooling problem.
The recommended operating temperature was exceeded. Perform one or more of
the following:
 Make sure that the cooling fan is rotating and is quiet.
 Remove any blockage that prevents air from flowing freely through the drive.
 Make sure that the operating temperature and airflow is within the specified
range (refer to the tape drive documentation for these specifications).
If the operating temperature is within the specified range and the problem
persists, contact Spectra Logic Technical Support (see Contacting Spectra Logic
on page 7).
Note: The error code clears when you reset or power cycle the drive or when
you place it in maintenance mode.
Power problem.
The externally supplied power is approaching the specified voltage limits (the
drive is still operating) or is outside the specified voltage limits (the drive is not
operating).
If the problem is only exhibited by one drive in the library:
 Make sure that the library's power connector is properly seated.
 If the problem persists, contact Spectra Logic Technical Support (see
Contacting Spectra Logic on page 7).
Note: The error code clears when you reset or power cycle the drive or when
you place it in maintenance mode.
If the problem is exhibited by multiple drives in the library:
The power throughout the library needs to be checked. Contact Spectra Logic
Technical Support for assistance (see Contacting Spectra Logic on page 7).
Interpret the Detailed Drive Information
User Guide—Spectra TFinity Library
419