Viewing And Saving A Detailed Drive Health Report - Spectra TFinity User Manual

Chapter 10 — Using Drive Lifecycle Management
The drive health icon state is based on data collected for the drive when the
last cartridge was loaded in the drive. This data consists of the code
presented on the drive's SCD or MCD, as well as tape alerts, and errors
detected at the time the tape is unloaded. See Interpreting the SCD and
MCD Codes on page 417 for detailed information about the SCD and MCD
codes. The following table describes the drive health status icons.

Viewing and Saving a Detailed Drive Health Report

1. Log into the library as a user with superuser or administrator
2. From the toolbar menu, select Configuration > DLM to display the
November 2020
Note: Not all SCD and MCD codes have an associated DLM icon.
Icon Meaning
The drive health is Good.
The drive is operating normally.
The drive requires Attention.
Use the SCD or MCD code information on the Drive Details screen to
determine the type of action required. See Interpreting the SCD and
MCD Codes on page 417 to determine what action is needed to address
the condition.
The drive health is Poor.
The drive has experienced an unrecoverable error or problem. Use the
SCD or MCD code information on the Drive Details screen to determine
the type of action required. See Interpreting the SCD and MCD Codes on
page 417 to determine what action is needed to address the condition.
The drive health is Unknown. The status of the drive cannot be
determined.
privileges.
Drives screen.
Figure 201 Click Detail to view detailed information about a
drive.
Viewing and Saving a Detailed Drive Health Report
User Guide—Spectra TFinity Library
334