Spectra TFinity User Manual page 119

Chapter 4 — Configuring the Library
2. Click Edit next to Network Settings. The Network Settings screen
Figure 55 The BlueScale12.7.04.01 and earlier
Network Settings screen.
3. Decide which type of addressing you want the library to use.
For BlueScale12.7.04.01 or earlier:
For this field...
Address
Subnet
Gateway
For BlueScale12.7.04.02 or later:
For this field...
If the IPv4 check box is selected:
(if the IPv4 check box is not selected, the IPv4 address defaults to 127.0.0.1 and is effectively disabled)
Address
Subnet
Gateway
November 2020
displays.
 DHCP — T he library is issued an IP address by the DHCP server.
 Static (highly recommended) — T he library uses a fixed IP address.
If you select static addressing, enter the following information:
Note: When entering IP addresses, do not include http: or https:
Enter...
A valid IPv4 address.
The subnet mask. The subnet mask must be a valid IPv4 address.
A valid network gateway IPv4 address. Enter 0.0.0.0 for the Gateway if your
network does not use a gateway.
Enter...
A valid IPv4 address.
The subnet mask. The subnet mask must be a valid IPv4 address.
A valid network gateway IPv4 address. Leave the field blank if the network
does not use a gateway.
Figure 56 The BlueScale12.7.04.02 and later
Network Settings screen.
User Guide—Spectra TFinity Library
Configure Network Settings
119