Spectra TFinity User Manual page 133

Chapter 4 — Configuring the Library
2. From the toolbar menu, select Configuration > Controllers to display
3. Identify the controller that you configured to provide the robotic
4. Click Failover next to the controller you want to be the primary
November 2020
the Controllers screen.
Figure 64 The Controllers screen before the failover
controller is selected.
control path in a partition (see Select the Robotic Control Path on
page 195). This controller is the primary controller in the failover pair.
If you have not yet configured partitions, identify two RIMs.
Note:
Both RIMs must be the same type and at the same firmware
version.
controller in the failover pair. The Controller Failover screen displays
with a list of the other RIMs in the library that can be used as the
failover partner.
 The component identifiers for the RIMs show them as F‐
Notes:
QIPs. See RIM Identifiers on page 69 for more information.
 Only controllers the same type (RIM or RIM2) as the first
controller selected, are listed as possible failover partners.
Figure 65 The Controller Failover screen.
Configure Controller Failover
User Guide—Spectra TFinity Library
133