Configure Routine Maintenance - Spectra TFinity User Manual

Chapter 4 — Configuring the Library

Configure Routine Maintenance

Overview The Routine Maintenance option configures the library to
automatically reset (reboot) the LCM once a week. Using this option is not
required as part of normal library operation and should be left disabled
unless you are requested to enable this by Spectra Logic Technical Support
in the course of troubleshooting or problem resolution.
Do not enable this option unless specifically instructed to do so by Spectra Logic
Important
Technical Support.
Enable the Routine Maintenance Option Use the following steps if Spectra
Logic Technical Support instructs you to enable the Routine Maintenance
option.
1.
2. Click Edit next to Routine Maintenance in the Other Settings pane. The
3. Select Enable to enable the Routine Maintenance option.
4. Use the Day of Week and Hour drop‐down lists to select when you want
5. Click Save to finish. Click Previous to return to the System Setup screen.
November 2020
Access the System Setup screen (see Accessing the System Setup Screen
on page 106).
Routine Maintenance Configuration screen displays.
Figure 62 The Routine Maintenance Configuration screen.
the automatic reboot to occur.
Note: When the library automatically resets, all data storage
operations currently in progress fail. Spectra Logic recommends
that you select a time when you are not performing data storage
operations.
Configure Routine Maintenance
User Guide—Spectra TFinity Library
129