Configure Mail Users - Spectra TFinity User Manual

Chapter 4 — Configuring the Library
For this field...
If the IPv6 check box is selected:
Address
Prefix
Gateway
4. Optionally, enter the IPv4 address for a Domain Name Server.
5. Click Save to change the IP addressing.

Configure Mail Users

Overview The library can send email messages with system messages,
traces, and diagnostic results to selected recipients. These recipients can be
configured to receive messages automatically as they are generated by the
library, or on demand when traces are run, reports are generated, or the
libraryʹs configuration data is backed up. Recipients can also be configured
to receive AutoSupport messages.
November 2020
Enter...
A valid IPv6 address. The library compresses the IPv6 address when saved.
Enter an integer between 1 and 128 to indicate the portion of the IPv6 address
that indicates a group of IP addresses on the same network.
A valid network gateway IPv6 address. Leave the field blank if the network
does not use a gateway.
If you plan to use NTP to automatically set the library's date and time,
you must enter a valid IPv4 address for at least one DNS server used by
the NTP service (see Set the Date and Time on page 124).
Note: To delete an already saved DNS setting, do one of the following:
 For BlueScale12.7.04.01 or earlier, set the IP address to 0.0.0.0.
 For BlueScale12.7.04.02 or later, clear the IP address.
 If you are connected to the library through the BlueScale web
Notes:
interface and you change the addressing, the library's IP
address changes as soon as you click Save. As a result, you
lose the connection to the library.
 If you are using the operator panel, select any option on the
toolbar menu to leave the Network Settings screen.
 The library must be connected to a network with Internet
Notes:
access before you configure mail recipients.
 You must configure the SMTP server used by the
autosupport@spectralogic.com mail user if you want to open an
AutoSupport ticket directly from the library (see
Chapter 11 – Configuring and Using AutoSupport,
beginning on page 339). This mail user is also used to send
the ASL and HHM files that the library generates to Spectra
Logic Technical Support when troubleshooting a problem.
User Guide—Spectra TFinity Library
Configure Mail Users
120