Spectra TFinity User Manual page 283

Chapter 8 — Using the Cartridge Inventory
9. After the move queue file uploads, the library parses the file to create
10.
November 2020
the move queue.
The parser ignores blank lines and case where possible. It does not
determine whether the moves or the order of the moves is possible. If
the parser encounters any parsing errors which are insurmountable or
if the file contains syntax errors, the library rejects the move file and
generates a system message indicating that the move file contained
errors and listing the line numbers where the errors were detected.
For example, if line 1 in the MoveQueue.txt file uploaded from the USB
device is BC000618L3;Slot, the library posts the following message
indicating that the line did not include a value for destination_num:
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
File \USB Disk\MoveQueue.txt has invalid moves in its list
Invalid Parse on line 1: BC000618L3;Slot
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
If the library detected an error in the move file, correct the move file
(see Create a Move Queue File on page 278) and then repeat Step 2 on
page 281 through Step 8 on page 282.
The library then processes the moves based on your selection in Step 8
on page 282.
Move Cartridges Using an ASCII Move File
User Guide—Spectra TFinity Library
283