Spectra TFinity User Manual page 462

Chapter 14 — Maintaining the Library
6. Using a #2 Phillips screwdriver, remove the two screws securing each
7. Place a cord lock over the connector on the end of the power cord that
8. Push the power cord into the input plug and reinstall the screws that
9. Tighten the cord lock clamp screws.
10. Repeat Step 7 through Step 9 for the other power cord.
November 2020
of the two input plugs to the dual AC module (circled in Figure 295 and
Figure 296).
Figure 295 Remove the screws securing the input plugs to the AC power
module (dual AC module shown).
Figure 296 Remove the screws on the service frame expansion power
module.
connects to the library. Orient the cord lock as shown in Figure 297.
Figure 297 Install the cord locks on the power cords.
secure the input plug to the dual AC module. Make sure that the cord
connector is fully seated in the input plug.
Manage Update Packages
User Guide—Spectra TFinity Library
Cord lock
clamp screw
462