Spectra TFinity User Manual page 390

Chapter 12 — Library Troubleshooting
10. On the Network General Settings screen, select Get IP address
11. Click Save.
12. After saving the new camera configuration verify the settings by
13. If the library has multiple cameras, repeat the steps in this section for
14.
15. When you have completed configuring the camera, close your browser
November 2020
automatically (DHCP) or Use fixed IP address.
If you select Use fixed IP address, set the desired IP, subnet mask, and
gateway addresses as required for your network and DNS (Domain
Name Server) information. The factory defaults are:
IP Address
10.10.10.11
 The Primary DNS address is required in order to use the
Notes:
email alert or dynamic DNS features.
 The Secondary DNS is optional. If provided, it will be used if
the Primary DNS is unavailable.
Figure 250 If you select Use fixed IP address, configure the
IP address for the camera.
attempting to access the camera at the new IP address (see Using a Web
browser on page 174).
each camera. Make a record of the IP address for each camera and the
frame in which each camera is located.
Other camera settings can be configured if desired. See the Vivotek
FD8361 Fixed Dome Network Camera User's Manual for information about
other available settings.
to exit the camera setup software.
Configure the BlueScale Vision Camera - Black
Subnet Mask Default Gateway
255.255.255.0
User Guide—Spectra TFinity Library
10.10.10.1
390