Spectra TFinity User Manual page 194

Chapter 6 — Configuring and Managing Partitions
1. From the SlotIQ screen, click Next. The Barcode Options screen
2. Select the checksummed behavior.
Use this parameter
Non-check-
summed barcodes
Check-summed
barcodes
(default)
Ignore check-sum
barcodes
3. Select from which side to truncate if not all characters are reported.
Use this parameter
Report left-hand
characters
November 2020
displays.
Figure 119 Select barcode options for the partition.
If...
Your labels do not include a checksum.
Your labels include a checksum and you want the barcode verified against the
checksum when it is read. Verification is not generally required, but adds extra
confirmation that the barcode label was read correctly by the barcode reader.
Your labels include a checksum character but you do not want the barcode
verified against the checksum when it is read.
If...
You want the library to report only the left‐most x characters in the barcode,
where x is any number from 1 to 16.
For example, if the barcode is 1234567L2 and you configure the library to report
only the five left‐most characters, the library reports the barcode as 12345.
Important: Be careful when specifying the number of left-most characters to
report. You may end up with duplicate barcodes reported. For example,
12345XXXL2 and 12345ABCL3 are both reported as 12345.
Select Barcode Options
User Guide—Spectra TFinity Library
194