Rear View - Lightware HDMI-TPS-RX110AY Series User Manual


  
3. Product Overview
3.2. Rear View
1 2
DC 12V IN Localpowerin;connecttheoutputofthesupplied12VDCpoweradaptor.
1
For more details see next section.
2 TPS IN (PoE) Locking RJ45 connector. Connect a twisted pair cable between the
transmitter and the receiver. Remote powering is also available through this
connector. Maximum CATx cable distances can be found in the
Extension Distances
3 SIGNAL status LED TheLEDgivesimmediatefeedbackaboutcurrentstateoftheHDMIoutput
signal. See the legend below.
4 HDMI OUT Connect an HDMI cable between the receiver and the local sink device.
Applied cable shall not be more, than 30 m (when the signal is 1080p) and
20m(whenthesignalis4K).
5 HDCP status LED The LED gives immediate feedback about current state of HDCP. See the
legend next to the table.
AUDIO OUT 5-pole Phoenix connector for asymmetric analog audio output. Pin
6
assignment can be found in the next section.
3 4 5 6
Maximum
section.
Appliedfirmwarepackage:v1.4.0 | LDCsoftware:v2.4.0b3
HDMI-TPS-RX110AY series – User's Manual
TPS Input LEDs
OFF:
ON:
OFF:
BLINKING:
ON:
SIGNAL LED for HDMI Output
OFF:
ON:
HDCP LED for HDMI Output
OFF:
BLINKING:
ON:
Remote power (PoE) is inactive, device is powered locally.
Remote power is active.
No TPS link between the transmitter and receiver.
Device is in low power mode or Ethernet fallback mode.
TPS signal is present.
Output signal is not present or muted.
Signal is present.
Output signal is not HDCP-encrypted.
Non-HDCP capable device is connected, encrypted signal is replaced with
red screen.
Output signal is HDCP-encrypted.
18