Product Overview; Front And Rear View - F-Series Endpoint Devices; Front View - Lightware UBEX Series User Manual

 
     

2. Product Overview

2. Product Overview
2
P roduct Overview
The following sections are about the physical structure of the device, input/
output ports and connectors; software and hardware capabilities:
ç Front and Rear View - F-series Endpoint Devices
ç Front and Rear View - R-series Endpoint Devices
ç Front and Rear View - UBEX-MMU-X200
ç Electrical Connections
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
2.1. Front and Rear View - F-series Endpoint Devices
2.1.1. Front View
All Models
1
1 Status LEDs The LEDs give immediate feedback about
the current status of the endpoint device.
See the details about the operation of the
LEDs in the Status LEDs
right side).
2 LCD screen LCD screen showing the most important
settings and parameters in the front
panel menu. The available settings and
information depends
application mode. See the details in
the Front Panel LCD Menu Operation -
Endpoints chapter.
3 Jog dial Easy setting and menu navigation by the
control knob jog dial control. Keep dialing and click while
getting feedback on the LCD.
Reset button Reboots the
4
disconnecting from the power source and
reconnecting again).
Status LEDs
LIVE
2 3 4
blinking The device is powered and ready to use.
STATUS
blinking
LINK OK
section (on the
blinking
on the current
MMU AVAILABLE
blinking
device (the same as
Transmitter / Receiver / Transceiver
off The device is not powered or out of operation.
Transmitter / Receiver / Transceiver
All measured temperature and voltage values are
on
within the limits.
Measured temperature or voltage value is out of
the limits.
off The device is not powered or out of operation.
Transmitter / Receiver / Transceiver
The connection is established on SFP+ LINK 1
on
and 2 and the Link Aggregation is working.
The connection is established on SFP+ LINK 1
and 2 and LACP detection period is active.
No connection is established on one of the SFP+
off
links.
Transmitter / Receiver / Transceiver
Matrix mode is active; the communication is live
on between the endpoint and the Matrix Management
Unit (MMU).
Matrix mode is active; no communication between
the endpoint and the MMU.
Extender mode is active; no communication
off
between the endpoint and the MMU.
17 17