Product Overview; Front And Rear View - F-Series Endpoint Devices; Front View - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     

2. Product Overview

2. Product Overview
2
P roduct Overview
The following sections are about the physical structure of the device, input/
output ports and connectors; software and hardware capabilities:
ç Front and Rear View - F-series Endpoint Devices
ç Front and Rear View - R-series Endpoint Devices
ç Electrical Connections
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
2.1. Front and Rear View - F-series Endpoint Devices
2.1.1. Front View
All Models
Status LEDs
1
2 LCD screen
Jog dial
3
control knob
4 Reset button
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
1 2 3 4
The LEDs give immediate feedback about
the current status of the endpoint device.
See the details about the operation of the
LEDs in the Status LEDs section (on the
right side).
LCD screen showing the most important
settings and parameters in the front
panel menu. The available settings and
information depends on the current
application mode. See the details in the
Front Panel LCD Menu Operations chapter.
Easy setting and menu navigation by the
jog dial control. Keep dialing and click while
getting feedback on the LCD.
Reboots the device (the same as
disconnecting from the power source and
reconnecting again).
Status LEDs
LIVE Transmitter / Receiver / Transceiver
blinking The device is powered and ready to use.
off The device is not powered or out of operation.
STATUS Transmitter / Receiver / Transceiver
All measured temperature and voltage values are
on
within the limits.
Measured temperature or voltage value is out of
blinking
the limits.
off The device is not powered or out of operation.
LINK OK Transmitter / Receiver / Transceiver
The connection is established on SFP+ LINK 1
on
and 2 and the Link Aggregation is working.
The connection is established on SFP+ LINK 1
blinking
and 2 and LACP detection period is active.
No connection is established on one of the SFP+
off
links.
MMU AVAILABLE Transmitter / Receiver / Transceiver
Matrix mode is active; the communication is live
on between the endpoint and the Matrix Management
Unit (MMU).
Matrix mode is active; no communication between
blinking
the endpoint and the MMU.
Extender mode is active; no communication
off
between the endpoint and the MMU.
14 14