Figure 11-67 Insert Connector For Handset Use; Figure 11-68 Remove Plastic Panels - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
14. For the Handset, set the connector in place.

Figure 11-67 Insert Connector for Handset Use

15. Attach the analog trunk cable and the handset cable. Refer to
Figure 11-60 PSA-L UNIT Connections on page
16. Reinstall the legs, pushing upwards until both locks snap into
place.
17. Return tilt leg to desired position.
18. Return the multiline terminal to the numbered keypad in the up
position.
19. Connect the Line cord, the PSTN cable and the Handset cord
(if used).
20. Remove both plastic panels from the front of the multiline
terminal.

Figure 11-68 Remove Plastic Panels

Issue 1.0
11-81.
11 - 85