Issue 1.0
8 - 54
8.1.3
Charging the Headset Battery
To charge the headset battery, place it in the docking cradle. During
charging, the charge indicator is On. When charging is complete the
indicator goes Off. The headset must be charged for a minimum of
one hour before use – three hours to fully charge.
8.1.4
Initial Setup
The Unit includes a ringer in the base to provide notification of an
incoming call when not wearing your headset. This feature is
enabled when the Ringer switch is down and is disabled when the
switch is up.
When the headset is installed, it sets itself as the default device in
your computer. You can set your preferences manually in Windows
through the Sounds and Audio Devices option in the control panel. A
softphone may require choosing the audio device and carries out a
short test to match this device to the softphone. It may also enable
you to choose which device indicates an incoming call. Refer to the
softphone documentation for more information.
8.1.5
Using the Headset
Refer to the User Guide for operating procedures.
UNIVERGE SV8100/SV8300
Installing SV8100/SV8300 Cordless Telephones