Figure 5-25 Chs2U-Us/Chs1U-Us Chassis Stand Mount - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
5 - 24

Figure 5-25 CHS2U-US/CHS1U-US Chassis Stand Mount

9. Connect the ground wire to all chassis. Refer to
Chassis Grounding on page 5-46
grounding the system.
10. Refer to
installation of the chassis or, Chapter 5 paragraph 2.2 Installing
an Extension or Trunk Blade on page 6-4 for installation of
blades.
3.3.2 CHS1U-US+CHS2U-USxN Chassis Installation
Expansion chassis (maximum of three) can be added to create a
UNIT and will require an additional CHS2U STAND KIT (EXT) per
chassis.
1. Using the spacing guide shown below, mark two holes to be
drilled. Refer to
(CHS1U-US+CHS2U-USXN Chassis Installation) on page 5-25
for required spacing before drilling.
3.5 Installing the 19" Chassis on page 5-34
Figure 5-26 Stand Mount Spacing Guide
UNIVERGE SV8100/SV8300
3.5.7 Install 19"
for complete details on
to continue
Installing the SV8300 Chassis