NEC Univerge SV8100 System Hardware Manual page 241

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

UNIVERGE SV8100/SV8300
3.1
System Hardware Manual
Internal Battery Mount
Figure 5-4 CHS2U-US Chassis (Rear View)
Wall Mounting the 19" Chassis
When wall mounting the chassis, ensure the wall can support the weight of the
chassis (31 lbs per system chassis including blades, cords, power supply,
etc.). The chassis is secured to the wall with a wall mount bracket. Ensure
that enough space is available to allow the installation of additional expansion
chassis.
3.1.1
CHS1U-US and CHS2U-US Chassis Installation
1.
Using the spacing guide shown below, align two wall mount
brackets. Refer to
Chassis) on page 5-8
✎ Select screws to match with the wall type as follows:
Fan Unit
(inside of cover)
Battery Connector
(inside of cover)
Figure 5-5 Wall Mount Spacing Guide (19"
for required spacing before drilling.
It is suggested that plywood first be
installed on the wall where the chassis
will be positioned. This allows for
secure anchoring of the screws which
will be supporting the weight of the
chassis.
For wall mount, only a single
CHS1U-US chassis and single
CHS2U-US chassis configuration is
available.
A concrete wall is recomended because it is the most firm to mount the
SV8300 of the two. The plaster board is the most firm wall of the two.
Issue 1.0
AC Connector
Frame Ground
(FG) Terminal
5 - 7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Univerge sv8300

Table of Contents