NEC Univerge SV8100 System Hardware Manual page 66

Issue 1.0
TELEPHONE/SERVICE PROVIDER COMPANY NOTIFICATION
Before connecting this telephone system to the telephone network, the following information must be
provided to the telephone company:
1. Your telephone number.
2. FCC registration number:
For SV8100 CHS2U-US (6-blade, 19" chassis) use SN1750 CYGMA:
When the system is to be installed as a Key Function system (no dial access to Trunk Groups/
Route Advance Blocks), use the following number:
US:NIFKF07BSN1750
When the system is to be installed as a Multifunction system, use the following number:
US:NIFMF07BSN1750
Ringer Equivalence Number (REN): 0.7B
USOC jacks required: RJ11C, RJEX, RJ2FX, RJ2HX, RJ48C
INCIDENCE OF HARM
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice is not
practical, the telephone company will notify the customer as soon as possible. Also, you will be advised
of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this happens, the telephone company will provide
advance notice in order for you to make necessary modifications to maintain interrupted service.
REPAIR SERVICE REQUIREMENTS
If the equipment is causing harm to the telephone network, the telephone company may request that you
disconnect the equipment until the problem is resolved.
If equipment malfunctions, all repairs must be performed by an authorized agent of NEC Unified
Solutions, Inc. or by NEC Unified Solutions, Inc. The user requiring service is responsible for reporting
the need for service to an NEC Unified Solutions, Inc. authorized agent or to NEC Unified Solutions, Inc.
R-2
UNIVERGE SV8100/SV8300
Regulatory