Figure 8-62 Incorrect Installation - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
8 - 50
7.2.4 Installing the Repeater
Be sure the wall material can hold the weight of
the repeater. Never install a repeater in
damaged or decaying wall material.
1. Hold the repeater in its final location, and mark the center of the
top edge.
2. From the edge mark, measure down approximately 1-1/2
inches, and mark the screw location.
3. At the screw location, use a 3/16ths drill bit to make a pilot hole
approximately one inch deep.
4. Place the wall anchor into the pilot hole and tap it gently with a
hammer until the anchor is flush with the wall.
5. Insert the mounting screw into the anchor, leaving
approximately 1/4 inch space between the screw head and the
wall.
6. Put the repeater over the screw head and slide it down into
place.
7. Connect the repeater to the 120 V AC power outlet.
7.2.5 Multiple Repeater Systems
You can register up to six repeaters to one base as long as the
repeaters are a minimum of 30 feet apart. Remember that the signal
can cross through walls and floors.
7.2.5.1 Incorrect Installation
Figure 8-62 Incorrect Installation on page 8-51
repeaters that have been incorrectly installed.
UNIVERGE SV8100/SV8300
Installing SV8100/SV8300 Cordless Telephones
illustrates