NEC Univerge SV8100 System Hardware Manual page 352

Issue 1.0
6 - 40
3.4.2 Installation
To install a PZ-VM21 on the CD-CP00-US or CC-CP00:
Do not remove or install the CD-CP00-US or
CC-CP00 with the power on.
1. Included with the PZ-VM21 are four plastic spacers. Install the
plastic spacers onto the PZ-VM21. Make sure to attach the
spacers so that they extend out on the side of the daughter
board which has the CN1 connector. Refer to
Installing the PZ-VM21 on page
2. For installation on the CD-CP00-US blade refer to
CD-CP00-US Blade with Daughter Boards Installed on page
6-15. For installation on the CC-CP00 blade, refer to
CC-CP00 Blade on page
3. Position the PZ-VM21 CN1 connector over the CN4 connector
on the CD-CP00-US
ensuring the plastic spacers lock in place.
4. Insert the CompactFlash card into the CN2 slot.
The LED1 status lights steadily when a card is installed.
UNIVERGE SV8100/SV8300
6-41.
6-25.
. Press the boards together,
blade
Installing the SV8100/SV8300 Blades
Figure 6-9
Figure 6-4
Figure 6-6