NEC Univerge SV8100 System Hardware Manual page 610

Issue 1.0
7.2
11 - 20
Installing an External Recording System or External Ringer
To connect to the PGD(2)-U10 ADP:
1. Make sure the jumper in the PGD(2)-U10 ADP for the channel is set
correctly. (Refer to Figure 11-4
page 11-4).
2. If a line cord was not previously connected to the PGD(2)-U10 ADP,
complete Steps 3-6. Otherwise, skip to Step 7.
3. Install a modular jack for each PGD(2)-U10 ADP. For each module, run
one-pair 24 AWG station cable from the cross-connect block to a
modular jack. Ground the unused pair.
4. Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
5. Install bridging clips as required.
6. Plug a modular line cord from the mod jack to the CN1 connector on the
PGD(2)-U10 ADP.
7. Connect an RCA jack to the audio output(s) on the back of the .
8. The opposite end of this cable is connected to the external recording
system or external ringer either directly or by connecting to the
cross-connect block where the item is connected. Refer to
PGD(2)-U10 ADP Cable Connection on page
UNIVERGE SV8100/SV8300
PGD(2)-U10 ADP Jumper Settings
11-21.
Installing SV8100/SV8300 Optional Equipment
on
Figure 11-15