Table 6-40 Pz-4Cotf Rj-61 Cable Connector Pin-Outs - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
6 - 76
5.2.2 Installation
To install the PZ-4COTF
1. Four plastic spacers are included with the COIDB. Install the
plastic spacers on the CD-4COTB or CD-LTA blade. Make sure
to attach the spacers so that they extend out on the side of the
daughter board which has the CN1 connector.
2. Position the PZ-4COTF CN1 connector over the CN4
connector on the CD-4COTB or CD-LTA. Press the blades
together, ensuring the plastic spacers lock in place.
3. Install the PZ-4COTF blade (refer to
PZ-4COTF Daughter Board on page 6-74
5.2.3 Connectors
Table 6-40 PZ-4COTF RJ-61 Cable Connector Pin-Outs on page
6-76 shows the pin-outs for the RJ-61 connector. Refer to
6-24 Installing the PZ-4COTF Daughter Board on page 6-74
illustration showing the location of the connectors on the PZ-4COTF
blades.

Table 6-40 PZ-4COTF RJ-61 Cable Connector Pin-Outs

The CN2 connector is polarity sensitive (tip-to-tip, ring-to-ring).
:
RJ-61 Cable Connector
CN2, Trunks – Connecting to COIU Blade
Pin No.
1
2
3
4
5
6
7
8
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300
Figure 6-24 Installing the
).
Figure
for an
Connection
Circuit 8 – Tip
Circuit 7 – Tip
Circuit 6 – Tip
Circuit 5 – Ring
Circuit 5 – Tip
Circuit 6 – Ring
Circuit 7 – Ring
Circuit 8 – Ring