Figure 5-38 19" Chs1U-Us Controlling Chassis - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
Ensure that you have a building plan showing common equipment,
extensions, the Telco demarcation and earth ground location before
you start installation. Be sure to properly plan your installation site
and that you are familiar with the installation safety precautions. If
you have not done that, please do so now. Refer to
Preparation and MDF/IDF Construction on page
3.5.2 Before Installation
Before installing the chassis check the following:
Ensure that the PSU is OFF and that the power cord is disconnected
from the AC outlet.
When installing the blades, do not touch the soldered surfaces as this
may cause damage.
Follow safety precautions indicated in section
Information on page
3.5.3 Installing the 19" Controlling Chassis
1. Ensure the chassis is powered down.
2. Align the CC-CP00 blade with the slot guide of the Controlling
Chassis.

Figure 5-38 19" CHS1U-US Controlling Chassis

5-1.
Do not remove or install this blade with the
power on.
Issue 1.0
Section 2 Site
5-1.
2.1 Precautionary
5 - 35