NEC Univerge SV8100 System Hardware Manual page 517

UNIVERGE SV8100/SV8300
In an ideal state, this terminal can be switched between cordless and the Multiline
Terminal connected to it using Cordless or Desk key on the base unit.
3.1
3.2
System Hardware Manual
Selecting an Installation Location
Select a location to avoid excessive heat or humidity. The base unit should be
placed on a desk or tabletop near a standard 120 Vac outlet and within reach
of the telephone line connection on the UNIVERGE SV8100/SV8300 Multiline
Terminal. Keep the base unit and the handset away from sources of electrical
noise (e.g. fluorescent lighting).
Connecting the Telephone Cords
term
The D Cordless II terminal is connected to the telephone line and to the
host telephone using two telephone line jacks on the back of the Base Unit:
LINE IN and LINE OUT.
Observe the following warnings during installation:
Never install telephone wiring during a lightning storm.
Never touch uninsulated telephone wires or terminals unless the telephone
line is disconnected at the network interface.
term
Figure 8-4 D Cordless II
Issue 1.0
8 - 5