NEC Univerge SV8100 System Hardware Manual page 638

Issue 1.0
11 - 48
11.5.6 Installation
DO NOT install the NEC BackOffice Software
until instructed! It is critical that you follow the
steps in the installation procedure in the order
listed below. Failure to do so will result in an
unsuccessful installation.
11.5.6.1 Location Preparation
The wiring for the extensions should be within six feet of
the PC location. For this reason, the PC for the NEC
BackOffice Recorder should be located near the MDF for
extension wiring.
The installer will need to prepare the wiring to tap off the
digital pair with a T-Connect type setup.
It may be desirable to fasten the devices to a PC or rack.
Since the devices are light in weight, this can be done
quite easily with Velcro tape.
11.5.6.2 Set Up PC
1.
2.
Set up the PC with the appropriate number of USB
Controller Cards and/or USB hubs for the number of
4-Port Digital Call Logging Unit devices (do not
connect more than four devices to each USB
Controller Card). Follow the installation instructions
for the Controller Card carefully. The PC should be
connected to the LAN for supervisor access as well
as to facilitate Windows and software updates as
needed. Additionally, it may be desirable to load
PC Anywhere on the PC for remote administration
of the application.
Once USB cards are installed, go to
www.windowsupdate.com. Download and install
any updated device drivers that may be available for
WIN2000 or XP and your USB Controller Cards.
This is very important, as WIN2000 does not always
have the required device drivers loaded in default
for USB 2.0 devices. If your card came with a driver
CD this step may have been taken care of during
installation of the card(s).
Installing SV8100/SV8300 Optional Equipment
UNIVERGE SV8100/SV8300