Figure 7-18 Ip Terminal Connector Locations - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
4.3
System Hardware Manual
Connecting the IP Multiline Terminal to the Network and PC
These instructions for connecting an IP Multiline Terminal to the Network and
PC apply to DT700 Multiline Terminals. Refer to
Connector Locations.
1. Connect the LAN Network
connector.
2. The IP terminal has a switching HUB to connect a PC to the LAN
Network. Connect the 10 Base-T/100 Base-TX straight cable used for
this connection to the PC(x) connector and to the PC.
Refer to Figure 7-19 Typical Network IP Connection on page
LAN (=) PC(x)
Connections

Figure 7-18 IP Terminal Connector Locations

Figure 7-18 IP Terminal
10Base-T/100Base-TX
Issue 1.0
cable to the LAN (=)
7-24.
7 - 23