Remove And Install Cooling Fan; Chs1U-Us Chassis; Remove Cooling Fan; Figure 5-100 Chs1U-Us Chassis Access Panel - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
R
S 5
EMOVE AND
ECTION
If required, the cooling fan installed in the CHS1U-US and the CHS2U-US chassis
can be removed and replaced. The following provide separate procedures for both
types of chassis.
5.1
System Hardware Manual
I
NSTALL

CHS1U-US Chassis

5.1.1

Remove Cooling Fan

1. Ensure the chassis is powered down.
2. Loosen retaining screw from chassis access panel.

Figure 5-100 CHS1U-US Chassis Access Panel

C F
OOLING AN
To reduce the possibility of electrical shock or
damage to equipment, NEC recommends
powering Off the chassis and disconnecting the
AC cable from the power source before
removing the chassis cover.
To reduce the possibility of damage to
equipment, the installer must wear a
grounded wrist strap to protect the
equipment from static electricity.
Retaining Screw
Issue 1.0
5 - 73