Table 10-5 Keypad Functions - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
4.2
4.3
10 - 10
Connecting and Charging the Batteries
To connect and charge the batteries:
1. Slide the cover off the battery compartment on the bottom of one pod.
2. Connect the battery pack plug in the port in the compartment and install
the battery pack.
3. Slide the cover back in place.
4. Connect the power supply/charger to the conferencing pod and plug it in
an electrical outlet.
Charge batteries for 15 hours prior to first use.
5. Repeat steps 1~4 for the other pod.
Keypad Functions
Refer to Table 10-3 Keypad
Key
ON/OFF key
(telephone icon)
PHONEBOOK (book
icon)
REDIAL (circular
arrow icon)
CONFERENCE
(three person icon)
FLASH (lightning
flash icon)
CLEAR (vertical line
and left arrow icon)
VOLUME (loud and
dim speaker icons)
MUTE (mic with
diagonal line icon)
Functions.

Table 10-5 Keypad Functions

Press to activate the telephone and access dial tone.
Press again to hang up and return to standby mode.
Press to dial stored numbers. Press and hold two seconds
to enter Phonebook Edit mode.
Press once to dial the last number called. Press and hold
two seconds to enter Program mode.
Press to dial the conferencing service provider. This
feature must be programmed.
Press to enable call forwarding, call waiting, or three-way
calling when supported by telephone service.
Press to clear the last digit entered or press and hold to
clear all numbers.
Press to exit programming mode.
Press during call to adjust call volume or press while
telephone is ringing or in standby mode to adjust ringer
volume.
Press to mute sound.
Installing SV8100/SV8300 Conference Solutions
UNIVERGE SV8100/SV8300
Function