NEC Univerge SV8100 System Hardware Manual page 595

UNIVERGE SV8100/SV8300
System Hardware Manual
4. Strip one end of the cable to be connected to the control relay or door
box so that approximately 1/4" (8 mm) of bare wire is exposed.
5. Insert the cable into the proper CN4 or CN5 location while holding down
the lock button (holding down this lock button is easiest with a flat-head
screwdriver). Once the cable is in place, release the lock button.
Refer to the specific function being connected for more detail on PGD(2)-U10
ADP connections.
Issue 1.0
11 - 5