Control And Status Word - KEB COMBIVERT F5 MULTI Applications Manual

Networks
11.2.8 Control and Status
Word
Control word low Sy.50
Control word high Sy.41
Control word long Sy.43
Chapter Section Page
11 2 4
The control word is used for the status control of the inverter via bus. With the status
word the current state of the inverter is read out.
Some parameters must be adjusted as follows, so that the inverter can respond to
the control word.
Bit Function
0 Control release 0 = control release not given; 1= control release given; if
1 Reset
2 Run / Stop
3 For / Rev
4-6 Current Set
7 reserved
8 Fast stop
9 Ref. Start
10 Posi Start
11 reserved
12-13 Mode
14-15 reserved
The control word high is bit-coded and structured as follows.
Bit Function
16 I1
17 I2
18 I3
19 I4
20 IA
21 IB
22 IC
23 ID
24 O1
25 O2
26 R1
27 R2
28
... free
31
The control word long (32 Bit) consists of Sy.51 and Sy.42.
Date Name:Basis
KEB COMBIVERT F5
04.05.04
Description
the control release is given via software, terminal ST
must be set. Moreover, all control releases are AND-
operated via software (di.1 Bit 0 and di.2 Bit 0 must be
set).
Reset out of the change from 0 => 1
0 = set rotation Stop; 1 = set rotation Run
(source of rotation op.1 = 8 or 9)
0 = set rotation forward; 1 = set rotation reverse
(source of set rotation op.1 = 8 or 9)
0...7 = parameter set 0...7 (source of set selection fr.2 = 5)
0 = fast stop inactive; 1 = fast stop active
1 = starts the homing procedure
1 = starts the positioning
1 = synchron running; 2 = positioning; 3= contouring mode
Description
Or-operation with di.2 Bit 4
Or-operation with di.2 Bit 5
Or-operation with di.2 Bit 6
Or-operation with di.2 Bit 7
Or-operation with di.2 Bit 8
Or-operation with di.2 Bit 9
Or-operation with di.2 Bit 10
Or-operation with di.2 Bit 11
Or-operation with ru.25 Bit 0
Or-operation with ru.25 Bit 1
Or-operation with ru.25 Bit 2
Or-operation with ru.25 Bit 3
©
Bus Parameters
KEB Antriebstechnik, 2002
All rights reserved