Analog Output / Display; Gain Of Output Characteristic; Characteristic - KEB COMBIVERT F5 MULTI Applications Manual

Functional Description
6.2.13 Analog Output /
Display
6.2.14 Gain of Output

Characteristic

(An.33...35 /
An.38...40 /
An.43...45)
Inverting the analog output
Chapter Section Page
6 2 12
Following parameters are used for the indication of the analog outputs, before and
after the characteristic amplification:
ru.33 ANOUT1 pre ampl. display
ru.34 ANOUT1 post ampl. display
ru.35 ANOUT2 pre ampl. display
ru.36 ANOUT2 post ampl. display
At the outputs ANOUT 3 and 4 there is no display provided.
After selecting the signal to be given out it can be adapted to the requirements by
means of characteristic amplifier in X/Y-direction or gain. With factory setting no zero
point offset is adjusted, the gain is 1, i.e. 100% of the variable to be given out correspond
to 10V at the analog output (see Fig. 6.2.14.a).
Function ANOUT1 -2
Gain An.33 An.38 An.43 An.49
X-Offset An.34 An.39 An.44 An.50
Y-Offset An.35 An.40 An.45 An.51
Fig. 6.2.14.a Factory setting: no Offset, Gain 1
An example for using the characteristic amplifier is shown in Fig. 6.2.14.b:
1. adjustment of the X-Offset (An.34) to 100 (%)
2. adjustment of the amplification (An.33) to -1.00
Fig. 6.2.14.b
-100%
Date Name: Basis
04.05.04
KEB COMBIVERT F5
-3 -4
output voltage
100%
An.33
-100%
An.34
100%
-100%
An.35
Inverting the analog output
An.35
These settings result in an inverting of
100% 10V
the analog signal.
An.33
An.34
100% correspond to 0V at the output
100%
-100%
Analog In- and Outputs
0...±400 %
0...±115 %
0...±400 %
0...±115 %
Value range Resolution Default
±20,00 0,01
±100,0% 0,1%
±100,0% 0,1%
displayable range
10V
variable to be indicated
0% correspond to 10V at the output
© KEB Antriebstechnik, 2002
All rights reserved
1,00
0,0%
0,0%