KEB COMBIVERT F5 MULTI Applications Manual page 240

Functional Description
Determine inputs (oP.56...oP58)
Input table
Motor potentiometer/Function
(oP .50)
Motor potentiometer/Rise time
(oP .59)
The correcting range
(oP.53, oP.54)
Display of motor potentiometer
value (ru.37)
Chapter Section Page
6 9 8
In the first step 2 inputs must be defined with which the motor potentiometer can be
increased or decreased. For that purpose one input each according to the input table
is assigned to the parameters oP.56 and oP.57. If both inputs are triggered
sumultaneously, the potentiometer values is decreased.
Increase motor poti value
Another input (oP.58) can be used to reset the motor potentiometer to the adjusted
reset value oP.55.
Bit -No. Decimal value
0
1
2
3
4
5
6
7
8
9
10
11
The basic working method of the motor potentiometer is defined with oP.50. The
parameter is bit-coded.
Bit oP.50 Motor potentiometer / Function
1 0
x 0 Motor poti is changed in the current set (default)
x 1 Motor poti is changed only in set 0
0 x Motor poti value is maintained after Power-on (default)
1 x Motor poti value is reset to reset value oP.55 after Power-on
With this parameter a time is defined, which the motor potentiometer needs in order to
run from 0...100 %. The time is adjustable between 0...50000 s.
The correcting range is limited by the parameters oP.53 and oP.54 (see Fig. 6.9.3.).
This parameter shows the current value of the motor potentiometer in percent.
Date Name: Basis
04.05.04 KEB COMBIVERT F5
Decrease motor poti value
⇓
oP.56
Input
1 I7/ST (Control release)
2 I8 Prog. input
4 I5 Prog. input
8 I6 Prog. input
16 I1 Prog. input
32 I2 Prog. input
64 I3 Prog. input
128 I4 Prog. input
256 IA (Internal input A)
512 IB (Internal input B)
1024 IC (Internal input C)
2048 ID (Internal input D)
Special Functions
⇓
oP.57
Terminal
X2A.16
X2A.17
X2A.14
X2A.15
X2A.10
X2A.11
X2A.12
X2A.13
none
none
none
none
© KEB Antriebstechnik, 2002
All rights reserved