Interbus Operator 00.F5.060-4000; Interbus Operator - KEB COMBIVERT F5 MULTI Applications Manual

Network Hardware
11.1.6 InterBus Ope-
rator
00.F5.060-4000
Fig. 11.1.6 InterBus Operator
It lights in the case of communication via
InterBus PCP or diagnostic interface
On: the remote bus interface (IB_out) was
turned off by the host
Diagnostic interface to the PC
The diagnostic interface is connected to the
PC via an adaptor and a HS5P-cable. By way
of the PC-software COMBIVIS one has now
normal access to all inverter parameters. The
internal operator parameters like Interbus
process data length and occupation can be
read and adjusted or parameterized through
download. Alternatively a monitoring of the
InterBus PCP as well as the process data
channels can be carried out with the PC-
software HSP5-monitor.
Separately available accessory:
HSP5-cable between PC and adaptor
(Part-No: 00.F5.0C0-0001)
Adaptor D-Sub9/Western
(Part-No: 00.F5.0C0-0002)
Chapter Section Page
11 1 6
The InterBus operator F5 is a slip-on operator with interbus 2-wire remote bus connection
for KEB COMBIVERT F5. The voltage supply occurs via the inverter, for an indepen-
dent supply it can also be fed in externally over the control terminal strip of the inverter.
Over the PCP channel 0, 1, 2 or 3 interbus register words can be configured for the
process data channel. Parallel to the field bus operation the operation via the integrated
display/keyboard as well as a further serial interface for diagnosis/parameterization
(COMBIVIS) is possible.
COM (green)
RD (red)
Diag
IB_in
1
6
IB_in
Remote bus input
(D-Sub 9-connector
Date Name: Basis
04.05.04 KEB COMBIVERT F5
START
ENTER FUNC.
F/R SPEED
STOP
ANTRIEBSTECHNIK
ANTRIEBSTECHNIK
IB_out
2 1
2 3 4 5 5 4 3
7 8 9 9 8 7 6
IB_out
Remote bus output
(D-Sub 9-bush)
Networks
BA (green)
On: Interbus runs
Blinking: Interbus was stopped by the
host
Off: Remote bus cable not available
or defective/host not in operation or
defective
E (red)
On: Ready for operation
Blinking: Inverter failure
Off: No supply voltage
RC (green)
On: Remote bus ready for operation
Off: Remote bus cable not available
or defective/host not in operation or
defective
© KEB Antriebstechnik, 2002
All rights reserved