KEB COMBIVERT F5 MULTI Applications Manual page 283

Positioning and Synchronous Control
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
© KEB Antriebstechnik, 2002
All Rights reserved
6.1 Operating and Unit Datas
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Setpoint- and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic Adjustment
6.6 Motor Data and Controller
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 Posi-/ Synchronous Control
and Contouring mode
6.12 Technology Controller
6.13 CP-Parameter Definition
Name: Basis
KEB COMBIVERT F5-M / S
Functional Desription
6.11.1 Synchronous Control ............... 3
6.11.2 Slave Correction ..................... 4
6.11.3 Position Controller ................... 5
6.11.4 Position Display ...................... 5
6.11.5 Reference Point Approach ....... 6
6.11.6 Reference Point Approach
Examples ................................ 7
6.11.7 Posi Control .......................... 12
6.11.8 Position sensing .................... 17
6.11.9 Teach mode .......................... 18
6.11.10 Contouring mode (CTM) ........ 19
6.11.11 Used Parameters .................. 20
Date
06.05.04
Chapter Section Page
6 11 1