KEB COMBIVERT F5 MULTI Applications Manual page 66

Operation
Relay output 1 / Function
Relay output 2 / Function
Chapter Section Page
4 3 20
CP.33 and CP.34 determine the function of the two outputs.
(terminal X2A.24...X2A.26 and X2A.27...X2A.29)
Value Function
0 No function (generelly off)
1 Generelly on
2 Run signal; also by DC-braking
3 Ready signal (no error)
4 Fault relay
5 Fault relay (not at under voltage error)
6 Warning or error message at abnormal stopping
7 Overload alert signal
8 Overtemperature alert signal power modules
9 External Overtemperature alert signal motor
10 Only application-mode
11 Overtemperature alert signal interior OHI
12-19 Only application-mode
20 Actual value = set value (CP.3 = Fcon, rcon; not at noP, LS error, SSF)
21 Accelerate (CP.3 = FAcc, rAcc, LAS)
22 Decelerate (CP.3 = FdEc, rdEc, LdS)
23 Real direction of rotation = set direction of rotation
24 Utilization > switching level
25 Active current > switching level
26 Only application-mode
27 Real value (CP.1) > switching level
28 Set value (CP.2) > switching level
29-30 Only application-mode
31 Absolut set value on AN1 > switching level
32 Absolut set value on AN2 > switching level
33 Only application-mode
34 Set value on AN1 > switching level
35 Set value on AN2 > switching level
36-39 Only application-mode
40 Hardware current limit activated
41 Modulation on-signal
42-46 Only application-mode
47 Ramp output value > switching level
48 Apparent current (CP.4) > switching level
49 Forward running (not at nOP, LS, abnormal stopping or error)
50 Reverse running (not at nOP, LS, abnormal stopping or error)
51 Warning E.OL2
52 Current regulator limit reached
53 Speed regulator limit reached
54-62 Only application-mode
63 Absolut value ANOUT1 > switching level
64 Absolut value ANOUT2 > switching level
65 ANOUT1 > switching level
66 ANOUT2 > switching level
67-69 Only application-mode
70 Driver voltage active (safety-relay)
71-72 Only application-mode
73
74
75 Only application-mode
1)
Switching level of CP.33 = 100; Switching level of CP.34 = 4
Date Name: Basis
17.05.04 KEB COMBIVERT F5-M / S
CP - Parameter
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
© KEB Antriebstechnik, 2003
All Rights reserved