KEB COMBIVERT F5 MULTI Applications Manual page 135

1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
© KEB Antriebstechnik, 2002
All rights reserved
6.1 Operating and Applicance
Date
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Set Value and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic (U/f)
Adjustment
6.6 Motor Data Adjustment
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 SMM, Posi, Synchron, CTM
6.12 Technology Control
6.13 CP-Parameter Definition
Name: Basis
KEB COMBIVERT F5
Functional Description
6.3.1 Summary Description
Digital Inputs .......................... 3
6.3.2 Input Signals .......................... 3
6.3.3 Setting of Digital Inputs by
Software ................................. 4
6.3.4 Terminal Status ....................... 5
6.3.5 Digital Filter ............................ 5
6.3.6 Inversion of Inputs .................. 5
6.3.7 Edge-triggering ....................... 5
6.3.8 Strobe-dependent Inputs ......... 6
6.3.9 Inputs Status .......................... 8
6.3.10 Reset/Input Selection and
Edge Evaluation ..................... 8
6.3.11 Assignment of the Inputs ........ 8
6.3.12 Summary Description
Digital Outputs ...................... 11
6.3.13 Output Signals ...................... 12
6.3.14 Output filter ........................... 12
6.3.15 Switching Conditions ............ 13
6.3.16 Inverting of Switching
Conditions for Flags .............. 16
6.3.17 Selection of Switching
Conditions for Flags .............. 16
6.3.18 Linking the Switching
Conditions for Flags .............. 16
6.3.19 Inverting of Flags ................. 17
6.3.20 Selection of Flags ................. 17
6.3.21 Linking the Flags .................. 17
6.3.22 Inversion of Outputs ............. 18
6.3.23 Output Terminal Status ......... 18
6.3.24 Hardware output allocation ... 18
6.3.25 Example ............................... 19
6.3.26 Used Parameters .................. 20
Date
28.01.03
Chapter Section Page
1
6 3 1